Maintaining; Specifications - Insignia NS-1DRVCR User Manual

Cannot play The disc was
disc a recorded in Video
recorded on mode
your
Some players will
recorder on
not play even a
another
finalized disc
DVD player.
recorded in Video
mode
The disc was
recorded in VR
mode
Discs recorded with
copy-once material
cannot be played on
other players
Cannot The remaining blank
record or space on the disc is
did not insufficient
record
successfully
The source you are
trying to record is
copy-protected
When recording to a
Video mode disc,
programs that are
copy-once
protected cannot be
recorded
Stereo Recorder A/V Out
Audio jacks are not
Record or connected to TV
Playback is A/V In jacks
not present
Recorder
Audio/Video Out is
not selected for
viewing at the TV

Maintaining

Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
30
Finalize the disc. See "Disc
Settings" on page 15.
No solution
The other player must be RW
compatible in order to play the
disc
No solution
Use another disc
You cannot record the source
Use a VR mode formatted disc
for copy-once material
Make A/V connections. Stereo
is available only on A/V output
from recorder.
Select AUX or A/V source as
TV input
www.insignia-products.com
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Note
Never operate this product immediately after
moving it from a cold location to a warm
location. Leave it for two or three hours
without operating it. If you use this product in
such a situation, it may damage tapes, discs,
or internal parts.
Resetting the recorder
Reset your recorder if you observe any of the
following symptoms:
• When the recorder is plugged in, but the
power will not turn on or off.
• When the display window does not working.
• When the recorder does not operate
normally.
To reset the recorder:
• Press and hold the POWER button for more
than five seconds. This forces the recorder to
turn off. Press the POWER button again to
turn the recorder back on.
- OR -
Unplug the power cord and then plug the
power cord again after more than five
seconds.

Specifications

General
Power requirements
Power consumption
Dimensions (approx.)
(w × h × d)
Mass (approx.)
Operating temperature
Operating humidity
Signal system
AC 120V, 60 Hz
24W
16.9 × 3.1 × 10.2 in.
(430 × 78.5 ×
266 mm)
10.14 lbs (4.6 kg)
41°F to 95°F
(5°C to 35°C)
5% to 90%
NTSC