Sony SRW-5800 Operation Manual page 149

Item number Item
612 VITC POSITION-2
select (NTSC)
613 TC OUTPUT
SIGNAL IN
REGENE MODE
614 PHASE
CORRECTION
616 VITC POSITION-1
select (PAL)
617 VITC POSITION-2
select (PAL)
618 LTC OUTPUT
PHASE select
619 EXT LTC MODE
620 SUPERIMPOSED
CHARACTER
Setting Function
12,281 line When 29.97PsF/59.94i mode is selected on the VTR, this
setting specifies the lines in which the VITC signal is
inserted.
[16,279 line]
It can be inserted in any lines from 12,281 to 20,283.
20,283 line
Note
Items 611 and 612 allow VITC to be inserted in two lines.
[off tape]
Specifies the signal output to the TIME CODE OUT
regene connector when the internal time code generator is in a
through mode for regenerating the playback time code (i.e. during
auto edit mode or when item 607 is set to "int-LTC" and
item 606 is set to "regene").
off tape: The playback time code signal is output to the
regene: The playback time code signal is output to the
through: The time code signal input to the TIME CODE IN
[off]
Specifies whether the phase correction control of the LTC
on signal generated by the time code generator is applied or
not.
off: The phase correction control is not applied.
on: The phase correction control is applied.
9,322 line When 25PsF/50i mode is selected on the VTR, this setting
specifies the lines in which the VITC signal is inserted.
It can be inserted in any lines from 9,322 to 22,335.
[19,332 line]
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
9,322 line When 25PsF/50i mode is selected on the VTR, this setting
specifies the lines in which the VITC signal is inserted.
It can be inserted in any lines from 9,322 to 22,335.
[21,334 line]
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
input Selects the LTC output phase.
auto input: Same phase as input video.
[output] auto: When editing, same phase as input video; otherwise
output: Same phase as output video.
direct Selects the recording mode when the internal time code
[regene]
generator is set to regenerate the input from the TIME
CODE IN connector (menu item 607 is set to "ext-LTC", and
menu item 606 is set to "regene").
direct: Records the time code input from the TIME CODE
regene: Regenerates the time code input from the TIME
[off]
Specifies whether or not to superimpose time data and
on operating status information on the signal output from the
MONITOR connector of SD SDI OUT, the SD OUT
COMPOSITE connector and MONITOR connector of HD
SDI OUTPUT.
off: No information is superimposed.
on: Information is superimposed.
TIME CODE OUT connector without regeneration.
TIME CODE OUT connector after regeneration only
when the VTR is in playback mode.
connector is output as it is.
(playback, recording, etc.), same phase as output
video.
IN connector unaltered on the tape.
CODE IN connector with the internal time code
generator.
149
Menu List