Page 1
Operating Instructions Rechargeable Shaver (Household) Model No. ES‑LF71 Before operating this unit, please read these instructions completely and save them for future use. ES-LF71_AUS.indb 2011/02/25 15:49:43...
Page 2
WET/DRY technology, you can enjoy using your or lack of experience and knowledge, unless they have been Panasonic shaver dry or in the shower or bath for gentle given supervision or instruction concerning use of the and easy shaving. Please read all instructions before use.
Page 3
Storing the shaver • Store the shaver in a place with low humidity after use. • Do not store the shaver where it will be exposed to direct sunlight or other heat sources. • Disconnect the power cord when storing the shaver. •...
E Self‑cleaning recharger STATUS lamp Parts identification Water tank cap Cleaning tray Water tank F AC adaptor (RE7‑59) Water maximum line Power cord Detergent cartridge Appliance plug Socket Travel case ...
Charge Insert the appliance plug into the shaver. Charging using the self‑cleaning recharger Plug in the AC adaptor into a Thoroughly wipe off any drops of water on or around the self‑ household outlet. cleaning recharger so that it is dry before charging the shaver. Insert the appliance plug into You cannot operate the shaver while charging.
Shave Pivot action selector Use to select “SOFT” (soft) or “LOCK” Using the shaver (lock). You can change the pivot action whether the shaver is turned on or off. Using the trimmer Slide the trimmer handle up. Place Rotate the lock ring to Hold the shaver at a right angle to your skin and move downwards to trim your...
Page 7
• Do not let the water rise above the maximum • Only use self‑cleaning recharger detergent for Panasonic water line. This may cause the cleaning liquid shavers. to spill. • Always change the detergent cartridge and the cleaning liquid in the water tank at the same time.
Cleaning the shaver Course Time required (guide) Use the self‑cleaning recharger in temperatures between 15 °C Charge 1 Charge and 5 °C. 0 to 60 min Insert the appliance plug into the self‑cleaning recharger. Remove the protective cap and 2 Clean/Dry/ Clean Charge...
Page 9
Follow the steps outlined below if the status Cleaning the shaver without the self‑cleaning recharger lamp blinks or glows 1. Disconnect the power cord from the shaver. Blinks Glows . Apply some hand soap and some water to the outer foil. Correctly set the Remove the shaver from the self‑...
Lubrication Replacing the system outer foil and the inner blades system outer foil once every year To maintain shaving comfort for a long time, it is recommended that the oil provided with the shaver is used. inner blades once every two years 1.
Replacement parts Do not pull hard on the rubber blade protector (a) at the bottom Replacement parts are available at your dealer or Service Center. of the cleaning tray. The rubber may come off if you pull hard on it.
• Perform steps 1 to 9 and lift the battery, and then remove it. For environmental protection and recycling of materials This shaver contains a Lithium‑ion battery. Please make sure that the battery is disposed of at an officially assigned location, if there is one in your country.