Subscribe to Our Youtube Channel
Related Manuals for McIntosh MCC222
Summary of Contents for McIntosh MCC222
- Page 1 OWNER’S MANUAL MCC222 Power Amplifier MCC222 McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549...
-
Page 2: Table Of Contents
18 Gauge (AWG) wire size or larger. If your loudspeaker cables are over 25 feet (38.1m) or If it is determined that your MCC222 is in need of repair, less, use at least 16 Gauge (AWG) wire size or larger. -
Page 3: Safety Instructions
Safety Instructions IMPORTANT SAFETY 7. Do not use attachments not recommended in this INSTRUCTIONS! owner’s manual as they may cause hazards. PLEASE READ THEM BEFORE Installation: 8. Locate the equipment for proper ventilation. For ex- OPERATING THIS EQUIPMENT. ample, the equipment should not be placed where the ventilation openings may be blocked as, that will im- WARNING SHOCK HAZARD - pede the flow of air through the ventilation openings. -
Page 4: Introduction
MCC222 power amplifier. Two MCC222 will have a long and trouble free operating life. 110 watt high current output channels will drive any high quality loudspeaker system to its ultimate performance. -
Page 5: Installation
Installation Installation It is recommended that the MCC222 and any associated It is not recommended that the amplifier not be mounted mobile audio equipment be installed by a professional who under the hood or in a location where it will be directly ex- is skilled in all aspects of installation and operation. -
Page 6: Side Panels Connections
MCC222 Side Panel Connections MCC222 Side Panel Connections Connect the MCC222 INPUTs for audio cables 80 Hz and 120Hz SUBWOOFER OUTPUTs to the vehicle battery from a control center supplies a two channel summed output below terminals audio outputs 80Hz or 120Hz... -
Page 7: How To Connect
How to Connect the MCC222 1. Connect the power control cable from the Control Cen- the amplifier chassis ter Remote Amp On to the MCC222 ON connector on directly to the right side of the amplifier. the vehicle 2. Connect cables from two separate loudspeakers to the... -
Page 8: Top Panel Controls, Displays And Switch
POWER GUARD LED lights POWER On Main Fuse holder, refer to information on when any amplifier channel Indicator the top panel of your MCC222 to deter- Power Guard circuit activates mine the correct fuse rating HI-PASS FILTER Left Input STEREO - BRIDGE... -
Page 9: How To Operate
Figure 4 and Right level controls are active, MCC222 level controls so the refer to figure 5. A good measure is to set the MCC222 Control Center volume is ap- level controls so the Control Center proximately at its mid position volume is approximately at its mid for normal listening levels. -
Page 10: Specifications
Specifications Specifications Dimensions Power Output Per Channel 10 inches (25.4 cm) wide, 9.5 inches (24.1 cm) high, 2.653 110 watts into 4 ohm load is the minimum sine wave con- inches (6.74cm) depth tinuous average power output per channel. Weight Power Output Bridged 6.6 pounds (3 Kg) net, 8.6 pounds (3.9 Kg) in shipping car- 220 watts into 4 ohm loads is the minimum sine wave con-... -
Page 11: Packing Instruction
If a ship- ping carton or any of the interior part(s) are needed, please call or write Customer Service Department of McIntosh Laboratory. Please see the Part List for the correct part... - Page 12 McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, NY 13903 McIntosh Part No. 040563...
Need help?
Do you have a question about the MCC222 and is the answer not in the manual?
Questions and answers