Fitting The Plinth Facia - Miele T 679 Ci Operating Instructions Manual

Fitting the plinth facia

– The appliance plinth below the door
can be concealed using a plinth
facia.
– The height and return of the ap-
pliance plinth cannot be altered.
– A taller plinth facia can only be in-
stalled if the overall niche height is
higher.
Plinth height Niche height
100 mm
(standard)
150 mm
200 mm
A plinth facia (60 cm long) can be or-
dered from your kitchen dealer or
manufacturer.
A cut-out must be made in the
plinth facia around the ventilation
slots otherwise the air flow to the ap-
pliance will be blocked and the ma-
chine will not work.
820 mm –
870 mm a spacer
frame is
required
920 mm 2 spacer
frames are
required
Fitting the plinth facia:
Place the small template supplied on
the back of the upper edge of the
plinth facia and fasten with sticky
tape.
Cut out the plinth facia according to
the template.
Cover the cut surface with the strip
supplied.
Stick the velcro fastener supplied to
the appliance plinth.
For this the following procedure is rec-
ommended:
Press the two halves of the velcro
fastener together lengthwise.
Cut into 2 or 3 pieces.
Peel off the protective backing from
one half of the velcro fastener
pieces.
Stick the pieces along the appliance
plinth, at the left and right hand edge
and in the middle. Press firmly into
place.
Peel off the remaining protective
backing strips.
Press the plinth facia firmly onto the
sticky surface of the velcro.
Installation
39