Miele T 679 Ci Operating Instructions Manual page 31

Check and indicator lights:
What to do if . . .
. . . once the programme has
started the following symbols
appear in the display:
"=== ... - == ...== ... - = ..."
. . . the programme is inter-
rupted, the "Anti-crease/Fin-
ish" indicator light comes on
and 0 appears in the display.
. . . the programme is inter-
rupted and "---" appears in
the display.
. . . shortly before the end of
the programme the count
down of the time left to run
halts at "10", but the dryer con-
tinues to dry.
Cause . . .
This is not a fault.
If there is no laundry in the drum when the programme is started, the
electronics will register this and stop the programme.
The programme will also be interrupted if the laundry placed in the
drum is already dry.
See the section on "What to do if the drying process goes on too
long".
This is not a fault.
One of the pieces being dried is
considerably larger than items
that have been dried in previous
programmes. The time left may
vary from that calculated by the
machine for a normal load.
Problem solving guide
Remedy . . .
See the "Display" section.
The drying process is not yet
complete. The programme
needs more time than the
electronic unit had calculated at
the start of the programme.
The time count down is
suspended until the degree of
drying selected has been
reached.
31