Default Factory Settings - NETGEAR WGT624 v3 Reference Manual

• If WPA-PSK or WPA2-PSK Authentication is Used:
– Passphrase: ______________________________ These characters are case sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network will not connect unless they are set to WPA-PSK as well and are configured
with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the
network will not connect unless they are aslo set to WPA2-PSK and are configured with
the correct Passphrase.
Use the procedures described in the following sections to configure the WGT624 v3. Store this
information in a safe place.

Default Factory Settings

When you first receive your WGT624 v3, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGT624 v3 wireless router, use the procedures below to customize any of the settings to better
meet your networking needs.
Wireless Access Point
Wireless Access List (MAC Filtering)
SSID broadcast
11b/g RF Channel
Authentication Type
Wireless Configuration
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
FEATURE DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
SSID NETGEAR
11
Mode g and b
Open System
WEP Disabled
v3.0, December 2005
5-9