Adjusting the Height of Cut
Height-of-cut is controlled by the lever located to the right of
the operating position (Figure 21).
2
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower the
lever until it engages the position.
The transport position is the highest height-of-cut position or
cutting height 115 mm [4.5 inch] (Figure 21).
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in Figure 22 to
match the closest height-of-cut position.
3
1
G014476
Figure 21
3. 115 mm (4.5 inch),
Transport position
G010233
3
1. Anti-scalp roller
2. Bolt
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 23).
1
1. Adjustment bolt
2. Move the seat to the desired position and tighten the
bolts.
21
4
1
2
Figure 22
3. Flange Nut
4. Hole spacing
G014477
Figure 23