Table of Contents
Advertisement
7. Move to the left side of the machine. Check if the side
carriage bolt is in the fixed or slotted position (Figure
53).
8. If the side carriage bolt is in the fixed position, remove
the side carriage bolt and side locking nut from the
fixed position and install it into the slotted adjustment
position (Figure 53).
If the bolt is in the slotted position, the carriage bolt
and side locking nut do not need to be removed.
5
3
4
Figure 53
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
9. Loosen the rear locking nut on the hanger bracket
(Figure 54).
3
4
Figure 54
1. Hanger bracket
2. Rear locking nut
10. Loosen the side locking nut on the hanger bracket just
enough to allow the hanger to be adjusted (Figure 54).
Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
G015323
1
2
4. Side locking nut.
5. Side carriage bolt
1
2
G015324
3. Side locking nut, slotted
position.
4. Adjustment notches
equivalent to 0.25 inch, while a single side is 0.125 inch
(Figure 55). Adjust the height of the mower deck to the
desired height.
1
2
1. 0.25 inch
11. Stop the deck at the adjusted position and tighten the
side locking nut on the hanger bracket to hold the new
position (Figure 54). Tighten the rear locking nut on
the hanger bracket.
12. Continue leveling the deck by checking the front-to-rear
blade slope; refer to Adjusting the Front-to-Rear Blade
Slope.
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install the
mower. If the front of the mower is more than 7.9 mm
(5/16 inch) lower than the rear of the mower, adjust the blade
level using the following instructions:
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Set the height-of-cut lever to middle position.
Note: Check and adjust the side-to-side blade level if
you have not checked the setting; refer to Side-to-Side
Leveling.
4. Carefully rotate the blades so they are facing front to
rear (Figure 56).
37
G015325
Figure 55
2. 0.125 inch
Advertisement
Table of Contents
