Shutting Down And Cleaning Up; Taking A Break; Winterizing And Long-Term Storage - CleanForce CF1400 Instruction Manual

ASSEMBLY AND OPERATING INSTRUCTIONS

SHUTTING DOWN AND CLEANING UP

1
detergent bottle and rinse it thoroughly.
2
Turn the switch to "OFF" (0) position.
3
Unplug the power cord from the outlet.
4
Turn off the water supply.
5
Press trigger to release any remaining water pressure.
6
Disconnect the garden hose from the water inlet on the unit.
7
Engage gun safety lock.
WARNING
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so
could result in personal injury due to discharge of high-pressure water.

TAKING A BREAK

If taking a break of five minutes or more:
1
Engage gun safety lock.
2
Turn unit to "OFF" (O) position.
3
Unplug the power cord from the outlet.
CAUTION
Failure to clean properly will cause the detergent injection system to become
clogged and inoperable.
CAUTION
Never use:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the surface being cleaned.
11

WINTERIZING AND LONG-TERM STORAGE

OPTIMUM WINTERIZING PROCEDURE
Winterizing your pressure washer will help protect and prolong its life. We strongly
recommend you follow the below steps using Pressure Washer Pump Saver (39-8602-0).
This will keep the internal parts lubricated, protected from rust, and prevents the pump
from freezing.
1
Connect Pressure Washer Pump Saver hose onto the water inlet.
2
Depress button on top of Pump Saver container.
3
4
Remove the hose from pump inlet ( water inlet).
QUICK WINTERIZING PROCEDURE
If you cannot do the Optimum Winterizing procedure, you can still protect your pressure
washer from winter-damage by doing below:
1
Disconnect all water connections.
2
Turn on the machine for a few
seconds, until the remaining water
in the pump exits. Turn off
immediately.
3
Do not allow high-pressure hose to
become kinked.
4
Store the machine and accessories
in a room that does not reach
freezing temperatures. Do not
store near furnace or other sources
of heat as it may dry out the pump
seals.
CAUTION
Drain gun assembly of any remaining water. Aim gun downwards and squeeze trigger.
Recommended: Pressure Washer Pump
Saver (39-8602-0)
12