Mastercook Dishwasher Instructions For Use Manual page 26

EN 13/ IF OPERATING ANOMALIES OCCUR
Problem
The appliance will not restart
The appliance does not drain
(Cf. table fault d02).
The appliance will no longer
function (Cf. table, fault 14).
• POOR WASHING RESULTS
Problem
Food traces, deposits, "sand
grains" in the glasses
Traces of grease
Possible auses
C
- Door opened during a wash-
ing cycle.
- The cover has not been
removed from the sink's U-bend.
- Drain hose kinked.
- Filters totally blocked.
- Pump blocked.
- Installation of non-compliant drai-
nage system: drainage too low
down or pipe pushed too far in.
- Siphoning: the appliance is
emptying as the same time as
it is filling up.
Possible auses
C
- Items poorly arranged (mas-
ked by another larger item or
situated underneath it, items
nested or jammed together).
- Upper rotor blocked by cutlery
or a dish etc.
- Filter poorly locked and lifting
during washing.
- Micro filter screen clogged.
- One or more holes in the rotor
blocked.
- Detergent dose too low; ineffi-
cient detergent ; stale product.
- Inappropriate programme
(temperature too low; duration
too short).
26
What to do ?
- Wait for the time delay for resu-
ming the cycle to end (control-
led internally by the appliance).
- Remove the cover.
- Check the drain hose line
behind the machine is OK.
- Remove and clean the filters
and the drain.
- Initiate a Soaking programme
If the fault persists, call a technician.
- Adhere to the drainage tube
installation dimensions.
What to do ?
- Arrange the items properly.
Use the most appropriate
areas and accessories for each
type of item (see instructions).
- Check that the rotor rotates
freely (gauge wire). Set the
basket in the high position if
necessary.
- Check the filter's facing and that
the filter is locked in place (push
it in fully, turning it to the right).
- Remove all, the filters and
clean them (in warm water),
including the micro filter's
screen (once a month).
- Remove the rotor by turning
the lever a quarter of a turn and
clean it under the tap (do not
use any tool that could damage
the holes). Re-install the rotor.
- Increase the dose ; try another
detergent.
- Select a programme with a
higher temperature.