Functional Description - Makita PW5001C Instruction Manual

disc extending beyond the pad presents a
laceration hazard and may cause snagging,
tearing of the disc or kickback.
Additional safety warnings:
17. Ground Fault
protection should be provided on the circuit(s)
or outlet(s) to be used for the tool. Receptacles
are available having built-in GFCI protection
and may be used for this measure of safety.
18. For additional protection against electric
shock, be sure to WEAR RUBBER GLOVES
AND RUBBER BOOTS during operation.
19. When using the water feed, be careful not to let
water get into the motor. If water runs into the
motor, an electric shock hazard may result.
20. PROPER GROUNDING. This tool should be
grounding while in use to protect the operator
from electric shock.
21. EXTENSION CORDS. Use only three-wire
extension cords which have three-prong
grounding-type
receptacles which accept the tool's plug.
Replace or repair damaged or worn cord
immediately.
22. Do not leave the tool running. Operate the tool
only when hand-held.
23. Always be sure that the tool is switched off
and unplugged or that the battery cartridge is
removed before carrying out any work on the
tool.
24. Check that
supported.
25. Pay attention that the wheel continues to
rotate after the tool is switched off.
26. Do not use the tool on any materials
containing asbestos.
27. Ensure that ventilation openings are kept clear
when working in dusty conditions. If it should
become necessary
disconnect the tool from the mains supply
( use non metallic objects ) and avoid
damaging internal parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Circuit Interrupter
plugs and
the workpiece is
to clear dust,

FUNCTIONAL DESCRIPTION

CAUTION:
(GFCI)
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Ground Fault Circuit Interrupter
2
1
3
011831
The tool is equipped with either of Ground Fault Circuit
Interrupter (GFCI) illustrated.
three-pole
Connect the tool to a power supply and test the Ground
Fault Circuit Interrupter (GFCI) before using the tool.
Push the RESET (R) button and confirm that the pilot
lamp lights. Push the TEST (T) button and confirm that
the pilot lamp goes out. Push the RESET (R) button
again to use the tool.
WARNING:
Do not use the tool if the pilot lamp does not go out
•
when the TEST (T) button is pushed.
properly
Shaft lock
1
first
004729
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
5
1. Pilot lamp
2. RESET (R)
button
1
3. TEST (T) button
2
3
1. Shaft lock
2. Cover
2