Cleaning And Care - iDect K1 User Manual

Troubleshooting
PBX use
"The Recall You may need to change the recall signal length from
its default of 100 ms. Consult your PBX documentation
function doesn't
for help if necessary. To change the flash time, use
seem to work."
the [Base Set] menu (page 46).
"Last Number When you first make a call, after keying in the outside
line access code (e.g. 9), press option to select
Redial and/or
" Insert Pause ". This inserts a pause between the
memory dialling
access code and the telephone number. You should later
don't work on
be able to redial the number.
a PBX."
When storing numbers in memory, you can include the
outside line access code (e.g. 9) with each number.
If the fault persists ...
Disconnect all other instruments connected to the
same line as the iDECT K1 and see whether you can
make a call.
Disconnect the base unit from the telephone line and
plug a different phone into the master telephone
socket. Try making a call. If this works, the line is OK.
If the call does not work, and you are using a two-way
socket adapter, remove it and plug a telephone
directly into the socket. If the call now works, the
adapter may be faulty.
If you cannot make a call, the fault may be on the
exchange line. Contact the service provider (the BT
engineers on 151, or your cable company).
If you still cannot identify the cause of the problem,
contact the Help Line on 0845 345 9677.
52

Cleaning and care

■ Do not clean any part of your iDECT K1 with benzene,
thinner or other solvent chemicals — this may cause
permanent damage which is not covered by the Guar-
antee. When necessary, clean it with a damp cloth.
■ Keep your iDECT K1 away from hot, humid conditions
or strong sunlight, and don't let it get wet.
■ Every effort has been made to ensure high standards of
reliability for your iDECT K1. However, if something
does go wrong, please do not try to repair it yourself
— consult your supplier or the Help Line.
Help Line: 0845 345 9677
(Local Call rate)
53