Comfort Airflow Operation - Daikin FTXS20G2V1B Operation Manual

01_EN_3P207037-1.fm Page 13 Monday, September 10, 2007 5:16 PM
■ To start 3-D Airflow
1. 3. Press the "SWING button
the " " and "
move in turn.
■ To cancel 3-D Airflow
2. 4. Press either the "SWING button

■ COMFORT AIRFLOW operation

• Check COMFORT AIRFLOW operation in the section of "COMFORT AIRFLOW Operation"
and "INTELLIGENT EYE Operation". (page 14.)
Notes on flaps and louvers angles
• When "SWING button" is selected, the flaps
swinging range depends on the operation
mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates
cold air, which tends to collected at the bottom
of the room, and hot air, which tends to collect
near the ceiling, throughout the room,
preventing areas of cold and hot developing.
■ ATTENTION
• Always use a remote controller to adjust the
angles of the flaps and louvers. If you
attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
• Always use a remote controller to adjust the
louvers angles. In side the air outlet, a fan is
rotating at a high speed.
" and the "SWING button
" display will light up and the flap and louvers will
In DRY mode or
COOL mode
COMFORT AIRFLOW
(page 14.)
In HEAT mode
In FAN mode
" or the "SWING button
5˚
15˚
50˚
Upper limit
Lower limit
Stop operation
Stop operation
30˚
Upper limit
70˚
Lower limit
80˚
COMFORT AIRFLOW (page 14.)
5˚
Upper limit
80˚
Lower limit Stop operation
":
".
13