Screen Menu - Sony Bravia HDMI VPL-AW15 Operating Instructions Manual

Screen Menu
The Screen menu is used to adjust the input signal. You can adjust the size of the picture,
and select wide screen mode, etc.
Adjust Screen menu
Wide Mode (When the
You can set the aspect ratio of the picture to be displayed for the
input signal is moving
current input signal. This item is enabled only when a moving
picture)
picture (preset memory numbers 1 to 14)
(C!I
page 61) is provided.
Wide Zoom: A 4:3 aspect ratio picture is enlarged over the entire screen
properly. The upper and lower portions of the screen are slightly cut
off.
Normal: A picture with normal 4:3 aspect ratio is displayed in the center
of the screen to fill the vertical screen size.
Full:
A picture squeezed to 4:3 is displayed with the correct aspect ratio.
A 4:3 picture is enlarged horizontally to fit the 16:9 screen.
Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and
horizontally in the same ratio to fill the screen.
Wide Mode (When the
You can set the aspect ratio of the picture to be displayed for the
PC signal is input)
current input signal. This item is enabled only when an PC signal is
input.
Full 1:
Displays a picture on the whole of the screen without changing
the aspect ratio of the original picture.
Full 2: Displays a picture on the whole of the screen.
Zoom:
A normal 16:9 aspect ratio picture is enlarged vertically and
horizontally in the same ratio to fill the screen.
Over Scan
Hides the outline of the picture.
On:
Hides the outline of the input picture. Select this setting when noise
appears along the edge of the picture.
Off: Projects the whole of the input picture.
Tip
To adjust the display area, refer to "Blanking" on the installation
~
menu
(C!I
page 49). (VPL-AWI5 only)
44