menu, the input terminal with effective
This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit
your taste.
Projecting the Picture on the Screen
1
Power on both the equipment
and the device connected to the
equipment.
2
Press INPUT repeatedly to
select the input you want to
project on the screen.
Display the indication of the input you
want.
Example: To view the picture
from the video
equipment connected
to the VIDEO INPUT
connector.
To view the picture from
Press INPUT to display
Video equipment connected to the VIDEO INPUT connector
Video
Video equipment connected to S VIDEO INPUT connector
S-Video
ROB/component equipment connected to the INPUT A connector
Input-A*
Component equipment connected to YIPs/CsIPR/CR connectors
Component
Equipment connected to the HDMI connector
HDMI**
* Set the "Input-A Signal Sel." setting in the Setup
d' ! :1
menu according to the signal input. When
you set it to "Auto," and cannot display the picture properly, select an appropriate signal
according to the input signal.
(Cir
page 47, 50, 61)
** The color gradation of the dark area or the bright area may become unclear when a signal other
than those from HDMI standard cable is input. Adjust the Brightness and the Contrast in the
Picture
III
menu.
(Cir
page 41)
Tip
When "Auto Input Search" is set to "On" in the Function
signals is automatically displayed by pressing INPUT.