Water Dispenser And Interface - GE GBSC0 Technical Service Manual

Note: When installing the water tank inlet tube, push
the inlet tube fi rmly into the water valve. Make sure
that the black mark on the tube is fl ush with the
bottom of the collar.
6. Remove the two 1/4-in. hex-head screws that
attach the water tank inlet tube cover to the
rear of the refrigerator.
7. Remove the water tank and inlet tubing from the
refrigerator compartment.
Black Mark
Water Tank Inlet
Tube Cover
– 49 –

Water Dispenser and Interface

The water dispenser assembly incorporates the
interface used for temperature control and features.
The interface has 2 tabs that hold it to the dispenser
shield. The tabs are located above 2 slots located
behind the bottom of the interface.
To remove the water dispenser assembly:
1. Using a fl at-blade screwdriver, push up on each
tab, then pry the bottom of the interface away
from the dispenser recess.
Slot
Slot
Slot
(Continued next page)