Table of Contents
Advertisement
Basic Setup
When wall-mounting unit used (vertically)
0 cm
Left
Notes
• Do not display the same picture (pattern) continuously for a long time. Doing so raises the brightness of the picture and
may cause after-images.
• Looking at the picture continuously for a long time can tire the eyes. View the display from a reasonable distance (about
three times the length of the screen).
• If something is wrong with the Plasma monitor internally the built-in protection circuit will cut the power automatically.
If so, the power lamp will blink in red, indicating a malfunction.
• If the power lamp is blinking red, it is warning that something is wrong with the Plasma monitor. There is a danger of fire
or electrical shock, so be certain to unplug the power cord and contact your product dealer. (See P44)
• The plasma display panel has been built using extremely precise and sophisticated technologies. More than 99.99% of its
pixels are effective. However, a minute number of pixels are missing or constantly lit.
• Do not install the Plasma monitor where there will be interference between it and other AV equipment. (If interference
from electromagnetic waves causes jumbled images, noise or malfunctioning of the infrared remote control, change the
installation location.)
• Warning : When the display is installed vertically, only still images appears.
P A G E 8
Upper
15 cm
10 cm
Right
10 cm
Lower
Power lamp
When mounting the Plasma monitor vertically, make sure that the power switch is at the lower
right.
Wall mounting
(vertical usage)
Wall
5 cm
206-3524-O
Advertisement
Table of Contents
