Step 3: Prepare Water Supply Connection; Step 4: Prepare The Dishwasher - LG Dishwasher Installation Manual

8
INSTALLATION INSTRUCTIONS
These installation instructions are intended for use by Qualified Installers.

STEP 3: PREPARE WATER SUPPLY CONNECTION

Make sure the house water supply is turned off before
connecting the dishwasher water lines.
1. This dishwasher must be connected to a hot water
supply between 120°F (49°C) and 149°F (65°C). This
temperature range provides the best washing re-
sults and shortest cycle time. To prevent damage to
dishes, temperature should not exceed 149°F (65°C).
2. When connecting the dishwasher water line, sealing
tape or compound should be used on pipe threads
to avoid leaks. Tape or compound should not be
used on compression fittings.
3. The water supply tube must be located in the left
side channel as shown in the figure.
NOTE
The instructions for appliances connected to the
water mains by detachable hose-sets shall state that
the new hose-sets supplied with the appliance are
to be used and that old hose-sets should not be re-
used.

STEP 4: PREPARE THE DISHWASHER

FIG. 6
Remove the rear plastic shipping brace for clearance and
ease of installation.
WARNING
Don't pull or lift with the handle; doing so can dam-
age the door and hinges. Open door and grab body
frame and top front opening of tub..
FIG. 5
Water
supply line
FIG. 7
Never move the dishwasher by the handle. This can cause
damage to the dishwasher.
FIG. 8
Always move the dishwasher by gripping the top frame.
Electrical
supply
6½" to 7¾"
(165 mm to 197 mm)