Prepare The Water Supply Connection; Prepare Dishwasher For Installation - LG LDS5540ST Service Manual

Step 3: PREPARE THE WATER SUPPLY CONNECTION
1. This dishwasher may be connected to either hot or cold water. If the water can not be
maintained below 149
2. When connecting the dishwasher water line, sealing tape or compound should be used to
avoid leaks.
3. When connecting the dishwasher water line, the house supply should be shut off.
4. The Water Supply Tube must be oriented as shown in
Step 4: PREPARE DISHWASHER FOR INSTALLATION
1. Adjust the legs to the required height to fit properly under the countertop as shown below.
2. Check the level of dishwasher by using level.
Left side – turn the
adjusting screw
counterclockwise to lower
the leg and raise the rear
of the dishwasher.
(65 ), the dishwasher must be connected to cold water.
Right side – turn the
adjusting screw clockwise
to lower the leg and raise
the rear of the dishwasher.
- 30 - - 30 -
- 35 -
For Authorized Service Technician
Figure A on page 34.
Front feet can be adjusted
from the top using a 1/4
square drive wrench.