Ariens 920006 Owner's/Operator's Manual page 9

Install Discharge Chute (Figure 5)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from the
bottom of the chute pedestal.
3. Install discharge chute over opening in
the auger housing and secure pedestal
to auger housing with hardware
removed in step 2.
1
3
1. Mounting Hardware
2. Discharge Chute
3. Discharge Chute Ring
4. Chute Pedestal
Figure 5
2
1
OS8030
Install Discharge Chute Crank
(Figure 6)
1. Slide Chute Crank through the opening
in the control panel.
2. Connect the chute crank to the pinion
gear on chute with spring clip pin.
4
1. Chute Crank
2. Control Panel
3. Pinion Gear
4. Spring Clip Pin
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage. If they do not, contact your Dealer
for repairs.
GB - 9
2
Figure 6
1
3
4
OS8025