Shear Bolts; Discharge Chute; Discharge Chute Deflector - Ariens 920006 Owner's/Operator's Manual

SHEAR BOLTS

IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear
bolt may result in severe damage to unit and
may void the warranty.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger,
breaking shear bolts which secure the auger
to the shaft (Figure 15). This allows auger to
turn freely on the shaft which may help
prevent damage to gear case and its
components.
2
1
1. Auger
2. Shear Bolts
Figure 15
For Replacement:
1. Align shear bolt holes in auger with
shear bolt holes in the shaft.
2. Drive shear bolt through hole (if shear
bolt was broken this will drive remaining
part from shaft).
3. Secure shear bolt with nut.

DISCHARGE CHUTE DEFLECTOR

Deflector must stay in selected position while
throwing snow.
To adjust, loosen then retighten the wing
knob to desired tension (Figure 16).
1
1. Wing Knob
2. Discharge Chute Deflector

3. Discharge Chute

DISCHARGE CHUTE
If discharge chute does not stay in position
while operating, tighten nut on carriage bolt at
pivot point to increase tension on spring
(Figure 17).
2
OS7150
1
2
GB - 21
2
3
Figure 16
1. Spring
2. Nut
1
2
Figure 17
OS8055
OS7177