Whirlpool 29 Installation Instructions Manual page 15

29" Wide Model Large Side-Swing Door
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
3.
Lift door off top screws
Lift door until top screws in cabinet are in large part of hinge Lift d til to i
slot. Pull door forward off screws. Set door on top of dryer.
Remove top screws from dryer cabinet.
bi t in l t of hin
4.
Remove and transfer hinge
hole plugs
Use a small, at-blade screwdriver to gently remove 4 hinge
hole plugs on left side of dryer cabinet. Insert plugs into hinge
holes on opposite side of dryer cabinet.
5.
Insert screws in hinge holes on
dryer cabinet
NOTE: Two people maybe needed to reinstall door.
Insert screws into bottom holes on left side of dryer cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
6.
Check door strike alignment
Close door and check that door strike aligns with door
catch. If needed, slide door catch left or right within slot
to adjust alignment.
15