Advertisement
Installing The Fence
(See Figure 2) Face the side of the Tile Saw with the
Power Switch, then loosen the Fixed Clamp on the
Fence. Slide the Fence with the Fixed Clamp toward
the front of the Tile Saw, over the left side of the
Table. Tighten the Fixed Clamp at the desired
position.
Figure 2
Before Operating The Tile Saw
Check the following points:
1.The motor and the supply voltage 120V, 60HZ) match. Use only grounded 3 wire receptacles. Do not attempt
to defeat the grounding feature. The power cord and the plug are in good condition.
2. Avoid using long extension cords.
3. Always place the cutting machine on a flat surface to prevent instability.
4. Choose the correct saw blade for the material to be cut. Use only diamond saw blades with a minimum
diameter of 6 inch and a maximum diameter of 7 inch. The shaft hole must be 7/8 inch.
5. FILL THE WATER TRAY. Be sure that the water tray is filled completely so that the saw blade turns through
enough water. This is necessary to cool the saw blade correctly.
6. The Tile Saw may be temporarily placed upon a flat, stable work surface for use, or permanently mounted
on a workbench.
Permanent Mounting Instructions
Make sure the power switch of the Tile Saw is in its "OFF" position and power cord is unplugged from
the electrical outlet prior to performing any assembly.
Make sure the workbench on which the Tile Saw will be permanently mounted is flat, level, and sturdy
enough to support the weight of the Tile Saw, any work pieces, and any additional tools.
1. Place the Tile Saw in the desired work location on the workbench. Use the four mounting slots on the Base
as a template to mark the areas where four mounting holes should be drilled through the workbench.
2. Temporarily remove the Tile Saw, and drill four mounting holes through the workbench. Make sure no
hidden electric cords or cables are in the drilling path.
3. Align the four long-mounting slots on the Base with the four predrilled mounting holes in the workbench.
Secure the Tile Saw to the workbench, using 4 appropriate length bolts, lock washers, and nuts (not included).
TCUT7UL 7" Bench Top Tile Saw
8
Advertisement
