Advertisement
19. Before starting the machine check that all safety devices and parts operate smoothly and
efficiently. Make sure that all moving parts are in good working order. Check the machine for any broken
parts. Make sure all parts are fitted properly and any other conditions that might affect the proper functioning of
the machine are correct. If not stated otherwise in this manual, damaged safety devices, switches and machine
parts must be repaired or replaced by a recognized service center. Do not use the machine when it cannot be
switched on or off.
20. For your own safety, use only accessories recommended in this manual.
21. Tool service must be performed by qualified repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk or injury.
22. When servicing a tool, use only identical replacement parts. Use of unauthorized parts or failure to
follow maintenance instructions may create a risk of electric shock or injury.
23. Never attempt to remove material stuck in the moving parts of the Tile Saw while the tool is turned
on, plugged in, or running.
24. Make sure the Tile Saw is located on a flat, level, sturdy surface capable of supporting the weight of
the Tile Saw.
25. Use the Tile Saw only for cutting ceramic tile, quarry tile, marble, terra cotta, and slate with a maximum
thickness on 1 inch, Never use the Tile Saw to cut metal or curves.
26. Before using the Tile Saw, make sure the blade is properly mounted, balanced and not cracked or
bent.
27. The blade will become hot while cutting. Allow the blade to cool completely before handling.
28. Allow the blade to spin to full speed before feeding a work piece into it. When turning off the Tile Saw
allow the blade to spin down and stop on its own. Do not press against the bade to stop it from spinning.
29. Never attempt to cut freehand. Make sure the tile to be cut is pressed firmly against the fence.
30. Always arrange a drip loop in the power cord connecting the Tile Saw to a 120 Volt, grounded,
electrical outlet. A drip loop is that part of the power cord below the level of the outlet, (or the connector if
using an extension cord), to prevent water from traveling along the power cord and coming in contact with the
outlet. If the power plug or electrical outlet does become wet, do not unplug the power cord. Disconnect the
fuse or circuit breaker that supplies power to the outlet. Then unplug and examine the outlet for presence of
water in the outlet.
31. Stand on a dry, insulated surface such as a rubber mat while using the Tile Saw.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT OPERATE THE
TILE SAW!
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. IT IS IMPORTANT THAT YOU READ
THE ENTIRE MANUAL TO BECOME FAMILIAR WITH THIS PRODUCT BEFORE YOU BEGIN USING IT.
TCUT7UL 7" Bench Top Tile Saw
5
Advertisement
