Advertisement
Specifications
Model
Current Draw Full Load
Current Draw No Load
Input Voltage
Weight
Grounding / Voltage Warning
Warning: Before using this tool, make sure that the power cord will be plugged into an outlet which has a
three-prong ground, is 120V AC, and is protected by a 15 Amp. Be sure the circuit breaker has a Ground
Fault Circuit Interrupter (GFCI).
Common household current is 110-120V. As long as the outlet used with the Tile Saw is rated from
110-120V there will be no complications using it with household receptacles. Plug the tool into a 110-120V
properly grounded outlet protected by a 15 Amp, dual element time delay or circuit breaker.
NEVER try to plug a 110-120V tool into a 220-240V circuit, or serious complications and possible injury to the
operator may occur. The plugs have different shapes to prevent this. This tool has a three-prong plug. The
third round prong is the ground. Cutting off the ground will result in a safety hazard and void warranty.
If the outlet you are planning to use is the two-prong type, do not remove or alter the grounding prong in any
way. Use an adapter and always connect the ground plug to a known grounding source. It is recommended
that you have a qualified electrician replace the two-prong outlet with a properly grounded three-prong outlet.
Extension Cords
Your tool has a three-prong plug; therefore you must use a three-prong extension cord. Only use rounded
jacket extension cords listed by the UL. Improper use of extension cords may cause inefficient operation of
your tool that can result in overheating. Be sure your extension cord is rated to allow sufficient current flow to
the motor. If you are using the tool outdoors, use an extension cord rated for outdoor use (signified by "WA" on
the jacket).
TCUT7UL 7" Bench Top Tile Saw
TCUT7UL
Frequency
3.75amp
No Load Speed
1.35amp
Motor Isolation Class
120V
Maximum Cutting Height
32 LBS
Work Table Dimensions
60Hz
3600rpm
Type B
1.34"
15 1/2" x 15 1/8"
6
Advertisement
