Settings Menu - InFocus LP 850 User Manual

Infocus user's guide projector lp 840 lp 850 lp 860
Hide thumbs Also See for LP 850:
Table of Contents

Advertisement

LP840-850-860 User's Guide-02.fm Page 35 Friday, February 25, 2005 12:58 PM

Settings menu

Audio: allows adjustments to the Balance and Volume. Also allows you to
turn on and off the Internal speakers, and projector startup Chime.
:
allows you to assign a particular input to a specific source key
Sources
when using the Integrator remote. Also allows selection of a default Startup
Source and enables or disables Autosource.
Sources>Power-up Source: this determines which source the projector
checks first for active signal during power-up.
Sources>Autosource: When Autosource is not checked, the projector
defaults to the source selected in Powerup Source. If no source is found, a
blank screen displays. When Autosource is checked, Powerup Source deter-
mines which source the projector defaults to at power-up. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
System>Rear: reverses the image so you can project from behind a
translucent screen.
Ceiling: turns the image upside down for ceiling-mounted projection.
IR Receivers: turns individual IR receivers off or on to avoid environ-
mental interference.
Auto Power: When Auto Power is checked, the projector automatically
goes into the startup state after the projector is powered on. This allows
control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as "Searching" or
"Mute") in the lower-left corner of the screen.
Low Power: toggles between on and off. Turn it on to lower the light out-
put of the lamp. This also lowers the fan speed, making the projector qui-
eter.
NND: prevents your notebook computer from going into Screen Save
mode (functions only when the USB connector is plugged in).
Power Save: automatically turns the lamp off after no signals are
detected for 20 minutes. After 10 additional minutes with no signal, the
projector powers down. If an active signal is received before the projec-
tor powers down, the image will be displayed.
Settings
menu
Sources
System
35
Audio
Powerup
Source
IR Receivers
IR Receivers

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lp840Lp860

Table of Contents