Table of Contents
Advertisement
Features
Power and Battery Requirements: The receiver is normally
powered by a 9V alkaline battery (Mallory MN 1604 or equivalent)
or by a heavy duty nickel-cadmium, 8.4 volt rechargeable battery,
(Telex Part Number 63912-000). For maximum uniterrupted service,
Telex recommends that a fresh battery be installed prior to use.
Average life on an alkaline battery is 6-8 hours and 1 1/2-2 hours per
charge on a nickel-cadmium (nicad) battery.
The ENG-1 portable receiver may also be powered by any filtered 8
to 24 VDC source via the DC power jack located on the side of the
unit.
The DC input is not intended for recharging NiCad
batteries.
DC Power "dc input" Jack: 1.1mm I.D.,
3.5mm O.D., Shaft 9mm
Line Output Jack: 3.5mm O.D. male,
Stereo Jack
CAUTION
-4-
Advertisement
Table of Contents
