Table of Contents
Advertisement
Figure 22
1. Chute handle
Clearing a Clogged Discharge
Chute
Important: Hand contact with the rotating
rotor blades inside the discharge chute is the
most common cause of injury associated with
snowthrowers. Never use your hand to clean out
the discharge chute.
To clear the chute:
• Shut the engine off !
• Wait 10 seconds to be sure the rotor blades have
stopped rotating.
• Always use a clean-out tool, not your hands
(Figure 23).
Figure 23
2. Chute deflector handle
Preventing Freeze-up after
Use
• Let the engine run for a few minutes to prevent
moving parts from freezing. Stop the engine, wait
for all moving parts to stop, and remove ice and
snow from the machine.
• Clean off any snow and ice from the base of the
chute.
• Rotate the discharge chute left and right to free it
from any ice buildup.
• With the ignition key in the Off position, pull the
recoil starter handle several times or connect the
electrical cord to a power source and the machine
and push the electric start button once to prevent
the recoil starter and/or the electric starter from
freezing up.
• In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive force
when trying to operate frozen controls. If you have
difficulty operating any control or part, start the
engine and let it run for a few minutes.
Operating Tips
WARNING
The rotor blades can throw stones, toys, and other
foreign objects and cause serious personal injury to
the operator or to bystanders.
• Keep the area to be cleared free of all objects
that the rotor blades could pick up and throw.
• Keep all children and pets away from the area
of operation.
• Remove the snow as soon as possible after it falls.
• If the machine does not propel itself forward on
slippery surfaces or in heavy snow, push forward on
the handle, but allow the machine to work at its own
pace.
• Overlap each swath to ensure complete snow
removal.
• Discharge the snow downwind whenever possible.
11
Hide quick links:
Advertisement
Table of Contents
