Selecting Ol/Ext Connection; Selecting The Length Of The "Flash (R Key)" Pulse - Bticino Terraneo 335022 Instructions For Use Manual

Terraneo

SELECTING OL/EXT CONNECTION

When installed the telephone is set up for connection to the
telephone exchange (EXT mode). If the telephone is connected
directly to the outside line it must be programmed with the OL
mode. To alter the mode proceed as follows:
Lift the receiver
Press the (PROGRAM) key
Press the 3
Press the 0 to set the EXT mode or key 9 to set the OL mode
Press the (PROGRAM) key to confirm the selection
Wait for the confirmation tone (3 beeps) and hang up.
SELECTING THE LENGTH OF THE "FLASH
(R KEY)" PULSE
3 different times can be associated with the flash key (
follows:
Lift the receiver
Press the (PROGRAM) key
Press the (FLASH) key
R
Press the between 1 - 3 to select the appropriate time:
1 = 100 ms
2 = 250 ms
3 = 500 ms
Press the (PROGRAM) key to confirm the selection
Wait for the confirmation tone (3 beeps) and hang up.
Note: the pulse time to be selected depends on the country
where the telephone is installed and is the password to the
exchange or STS functions (see "Using the main functions"
chapter).
) as
R
15
3
or
0
9
beep - beep - beep
R
- -
1 2 3
beep - beep - beep