Edge Cutting Metal; Maintenance Instructions; Failure To Start; Ventilation - RIDGID 5228 Operator's Manual

5228 Double Insulated Variable Speed, Dual Action Reciprocating Saw

Edge Cutting Metal

To cut metal from an edge, start the cut on the surface
where the greatest number of teeth will contact the work.
To avoid vibration of metal and blade chatter, hold saw
firmly against materiel while making cut.
To make a pocket cut in metal, first drill a starting hole
large enough for the blade to enter. To extend blade life
and facilitate better cutting, apply cutting oil to the work
surface along the line of the cut. Forcing saw into work
should be avoided. Allow saw blade to do the work
while guiding saw at moderate rate.

Maintenance Instructions

WARNING
Always unplug power cord before performing any
service on this tool.

Failure to Start

If the tool should fail to operate, confirm that the prongs
on the power cord are making good contact in the outlet.
Check for blown fuses or open circuit breakers in the line.

Ventilation

Keep air inlet passages clear to insure a cool running
motor. Periodically blow out all air passages with an air
jet. Wear safety glasses when performing this operation.
Never use solvents when cleaning plastic parts as this
could damage the finish.

Lubrication

After approximately 100 hours of operation, the saw
should be taken to a RIDGID Authorized Service Center
to be relubricated. At that time, the tool will be thor-
oughly cleaned and inspected and worn parts replaced
when necessary.
Ridge Tool Company • Elyria, Ohio • U.S.A.
Service & Repairs
If any maintenance or repair is required other than that
outlined above, the tool should be sent to a RIDGID
Authorized Service Center or returned to the factory.
All repairs made by Ridge service facilities are war-
ranted against defects in material and workmanship.
If you have any questions about the operation or function
of this tool, call or write to:
The Ridge Tool Company
Attention: Technical Service Department
400 Clark Street
Elyria, Ohio 44036-2023
800/519-3456
In any correspondence, please give all information shown
on the Nameplate of your tool including Model Number,
Voltage and Serial Number.
7