Baxi 829 Installer And Owner Manual page 5

INSTALLER AND OWNER GUIDE
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in doubt,
seek help from a competent person
Do I need any tools?
1. Depending upon the chosen method of installation you may need the following
screwdrivers: -
1 off Pozidrive / Phillips / cross head. This should have a number 2 size tip.
!
1 off Flat end.
!
2. If drilling into brickwork you will need a power drill (preferably with hammer action)
and appropriate size drill bit for the wallplugs supplied.
Where can I fit the heater?
There should be at least 50mm (2 inches) clearance between the top of the fascia and
anything such as a shelf, fireplace surround or mantel etc. This will allow the fascia to
be lifted off or removed during servicing. To check this gently place the fascia against
the surface to which it is to be fixed. Measure the distance from the top of the fascia.
Chic, Envy, Mirage and Serenity models.
The heater can be fitted into fireplaces or surrounds where the following dimensions are
available.
Width
Height
Depth
The heater can also be fitted against against a flat wall. A spacer frame is supplied with
the heater.
Twilight model.
The heater cannot be fitted into fireplaces / fireplace openings. It is intended for
installation to a flat wall. A spacer frame is supplied with the heater.
©
Baxi Heating U.K. Limited 2006.
FITTING THE HEATER
390mm - 450 mm (15.35 inches - 17.72 inches)
555mm - 590 mm (21.9 inches - 23.2 inches)
At least 75mm (At least 3 inches)
Page 5