Fitting The Fascia; All Models - Baxi 829 Installer And Owner Manual

INSTALLER AND OWNER GUIDE

Fitting the fascia.

Twilight fascia only.
1. There is a fuel bed support supplied with
the Twilight heater. Slip this between the
glass and metal panel on the rear of the fascia
opening as shown in figure 11.
Serenity fascia only.
1. There are two foam pads supplied with the
heater. Locate the pads into the rear of the
fascia as in figure 12.

All models.

1. There are two hooked brackets on the top
rear of the fascia. Locate the hooks into the
brackets at the top of the heater (See figure
13).
2. The fascia is secured using the two screws
with bright metal finish. These are located as
in figure 14.
Figure 13. Fitting the fascia (Fascia
may differ from that shown).
©
Baxi Heating U.K. Limited 2006.
Figure 11. Fitting the fuel support
bracket to the Twilight fascia.
Figure 12. Fitting the foam pads
on the Serenity model
Page 12