Ice Making Compartment (Automatic Ice Maker); Water Tank; Ice Tray - Mitsubishi Electric MR-E62S Operating Instructions Manual

Ice Making Compartment
(Automatic Ice Maker)
Water tank cap
Water tank lid
The lid can be set on the
tank in both directions,
facing the front or rear.

Water tank

(about 1.2 L)
Pipe
Water supply pump
Optical catalyst and
lead-cleaning fi lter

Ice tray

It can be removed
for cleaning.
Soundproof
mat
Reduces the sound
of dropping ice.
Do not dispose of it.
Ice server
z Clean the ice maker periodically to ensure that the ice is pure and delicious.
„ If the door alarm sounds
Ice making precautions
Do not place objects at the rear of the ice storage box.
Ice server
Door
Ice storage box
z
Do not store food higher than the ice storage box (because it may
cause an ajar door, malfunction or damage).
When using the regular or quick ice making setting, do not put
anything other than ice.
z
The level of the ice storage is checked automatically by the sensor
lever, and ice making is stopped when the ice reaches a certain level
(about 80 to 140 ice cubes). To ensure that the ice storage level is
detected correctly, make sure that the ice is fl at and that the ice server
24
is kept in its storage position in the front right of the ice storage box.
Ice storage box Ice tray lock lever
Page 11
Ice tray
Sensor lever
(Detects the ice
storage level.)
Lay fl at
Water tank setting
position line
Water supply pipe
V-LED lamp
Light is radiated on the optical catalyst
and lead-cleaning fi lter to prevent
breeding of bacteria
* The effect has been proven after 18 hours in
a test using a 12cm
in a sealed container with a 12 cm
these conditions vary from the actual operation
conditions.
The V-LED lamp turns on
• When the refrigerator compartment
or ice making compartment door is
open (the light turns off 5 minutes
after the door is opened)
• Before and after supplying water to
the ice tray
Page 26
Do not pour anything other than
cold water into the water tank, such
as warm water, juice, tea or other
liquids (the tank can resist heat up
to 60°C).
Pouring anything other than cold water into the
tank may damage the automatic ice maker or
water supply pump.
Do not pour water directly into the ice tray to make
ice.
Unfrozen water in the ice tray may fall into the ice storage box, and
the ice may join not forming cubes.
When ice is made using water with a high mineral
content, such as mineral water, white deposits
(white crystals) may form in the ice.
This is the crystallized mineral content and is not harmful.
This is the guideline for
the water tank setting
position.
Push in the water tank
until it makes contact
with the inner side. Make
sure that the line can be
seen in front of the water
tank.
*
inside the water tank.
2
fi lter bacteria-inoculated
2
fi lter, but