When Using The Ttl Cable - Olympus PT-E06 Instruction Manual

When using the TTL cable

When connecting the optional electronic flash with the underwater TTL cable (optional: PTCB-E01),
connect the hot shoe cable (optional: PHCB-01) to the camera and front cover of the Case.
Connecting the underwater TTL cable
1 Turn the TTL connector cap of the Case counter-
clockwise and remove it.
2 Connect the underwater TTL cable (optional:
PTCB-E01) to the TTL connector on the Case.
3 When not using the underwater TTL cable,
attach the TTL connector cap.
Make sure there is no foreign matter attached to the
O-rings inside the cap and on the TTL cable
connector. After that, gently turn it clockwise until it
stops.
Check O-rings
Cap
CAUTION:
If the TTL connector cap is loose, water leakage may result.
How to connect the hot shoe cable
1 Turn the hot shoe cable connector cap inside the Case counter-clockwise to remove it.
2 Insert the connector of the hot shoe cable into the Case's connector and turn the connector screws
all the way clockwise to connect them firmly.
3 Load the camera in the Case, and then connect the hot shoe cable to the camera.
Connector
Insert into the
connector.
Turn the threaded
section of the
connector clockwise
gently until it stops.
Underwater
TTL cable
Use this mark to
align the position.
En
EN 12