Service And Adjustments - McCulloch Twist ’N Edge Instruction Manual

NOTE:
Do not clean filter in gasoline or other
flammable solvent to avoid creating a fire haz-
ard or producing harmful evaporative emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Replace parts.
Button
Air Filter Cover

SERVICE AND ADJUSTMENTS

REPLACING THE LINE
Pre- -wound spools offer the most convenient
method for replacing line and ensuring opti-
mum performance.
S Replacement spools are color- -coded to
ensure use of the correct spool with your
unit. Be sure to use the same color spool as
the existing spool.
NOTE:
Always clear dirt and debris from
cutting head components when performing
any type of maintenance.
S Hold spool and unscrew cap by turning in
the direction shown on top of the cap.
S Remove line guide ring and spool.
Line guide ring
Cap
Use a pre- -wound spool or refill spool with
line. If using a pre- -wound spool, remove tape
strip from line and spool.
REFILLING THE SPOOL WITH LINE
WARNING:
Use only 2 mm diameter
round line. Other sizes and shapes of line will
not advance properly and will result in improp-
er cutting head function or can cause serious
injury. Do not use other materials such as
wire, string, rope, etc. Wire can break off dur-
ing cutting and become a dangerous missile
that can cause serious injury.
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts easier and runs better. Set
spark plug gap at 0,6 mm. Ignition timing is
fixed and nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card.
Air Filter
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 19 mm
socket wrench.
4. Reinstall the spark plug boot.
1. Cut a length of 8 meters of 2 mm diameter
round McCulloch® brand line.
2. Insert one end of line into center cavity of
empty spool. Ensure line will feed into
spool in the direction shown on the spool
Spool
(counterclockwise).
3. Continue feeding line into spool, leaving
10 - - 15 cm unwound from center of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring
3. Rest guide ring on spool and place line
through slot. Allow line to extend 10 - - 15
cm from center of spool.
4. Ensure line remains in slot while screwing
cap on to the shaft. Only tighten cap
hand tight!
8
Feed line in
direction
shown on
spool.
Spool
Slot
Replacement Spool