Using The Built-In Battery Or Ac Adapter; Basic Play; Stopping Play; Skipping Ahead Or Back - Transonic TC2620DVD Instruction Manual

U s n i g h t e b i u - t l n i b t a e t y r r o
There is a built-in rechargeable battery in the player. You can
operate your player by it. If the low power symbols flashes in
the display, or the display screen is blank when the Power
switch is in "on" position, your batteries are weak. Please use
the AC adapter instead. Plug one end of the AC adapter into
the DC IN jack of the player, then plug the other into an AC
outlet.
You can charge rechargeable batteries with the AC adapter.
Once the AC adapter is connected, the built-in battery is
charged in the player itself. During charging, the indicator
flashes. Charging time takes approximately 4-8 hours.
Important AC Power Notes:
Do not touch the power adapter with wet hands. Doing so is
dangerous, as this could result in an electrical shock.
If the power adapter is connected, the power supply is
automatically switched to the AC power source and the
batteries are disconnected.
Before enjoying DVD/ CD
If you would like to change the menu language to other
language, please refer to "LANGUAGE SETUP".
In the explanation given below is assumed that English has
been selected as the OSD language.

Basic Play

1. Turn the power switch to ON position.
2. Press OPEN/CLOSE to open the disc tray.
3. Place a disc onto the disc tray.
Hold the disc without touching either of its surfaces, position
it with the printed title side facing up, align it with the guides,
and place it in its proper position.
4. Close the CD door, and the player will start to read the disc
automatically.
5. When a menu screen appears on the screen, press the
navigation buttons or press the numeric buttons to select
preferred track number, then press the "ENTER" button to
confirm.
6. When the menu continues onto another screen, press the
"NEXT I" button to view the next screen, or press the
"PREV. I " button to skip to previous screen.
NOTE: Due to the different design of some software titles,
the "NEXT I" button may not always work.
7. To stop play and return to the menu screen, press the
"TITLE" button, or "MENU" button (which button is
pressed differs depending on the disc used).
For DVD, press "TITLE", "MENU" or "RETURN".
For VCD, press "RETURN".
A C a d a t p r e S o t p p n i g p a l y
Press "STOP "
For your convenience:
When player is stopped, the player records the point where
"STOP " was pressed (RESUME function). Press the
"PLAY II" again, player will resume from this point.
When the tray is opened or "STOP " is pressed again, the
RESUME function will be cleared.

Skipping ahead or back

Skipping ahead
Press the "NEXT I" button during play.
A chapter (DVD) or a track (CD) is skipped forward each
time the button is pressed.
Skipping back
Press the "PREV. I
A chapter (DVD) or a track (CD) is skipped backward each
time the button is pressed.
Rapid advance (Rapid reverse)
During playback, press the "
forward/rewind.
Press the "PLAY II" button to resume normal play.
The forward/rewind speed as follows:
2X -- 4X -- 8X – 20X

Step play

During playing, press the "STEP" button, the play will be paused,
and in this mode, each time the "STEP" button is pressed, the
player will only play one picture. To resume normal play, press the
"PLAY II" button.
--10--
" button during play.
" button or " " button to fast