Adjusting The Sound - JVC KD-G201 Service Manual

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the
button, the adjustable items
change as follows:
BAS
(bass)
VOL
(volume)
Indication To do:
1
*
BAS Adjust the bass.
1
*
TRE Adjust the treble.
2
*
FAD Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
* 1
LOUD Boost low and high
frequencies to
produce a well-
balanced sound
at low volume
level.
* 3
VOL Adjust the volume. 00 (min.)
TRE FAD
(treble) (fader)
LOUD BAL
(loudness) (balance)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
|
30 or 50 (max.)
1
*
When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the
currently selected sound mode (C-EQ) including
"USER."
2
*
If you are using a two-speaker system, set the fader
level to "00."
3
*
Normally the control dial works as the volume
control. So you do not have to select "VOL" to
adjust the volume level.
4
*
Depending on the amplifier gain control setting.
(See page 17 for details.)
2
Adjust the setting.
Ex. 1: When you adjust "TRE" (treble)
Ex. 2: When you turn on the loudness
3
Repeat steps 1 and 2 to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
reassign the preset values listed in the table on
* 4
page 14.
To increase the level or
turn on the loudness
To decrease the level or
turn off the loudness
Indication pattern changes as
you adjust the bass or treble.
15