Troubleshooting - LG CRD-8481B Owner's Manual

Installation, Usage and Handling Precautions
[ lnstallation
Avoid placing the drive in a location subject to :
- high humidity
- high temperature
- mechanical vibration
- direct sunlight
[ Operation
- During operation, excessive vibration or a sudden jolt to the drive may
cause a malfunction.
- Avoid exposing the drive to sudden changes in temperature. This may
cause condensation to collect inside the drive.
- Do not use damaged, cracked, or warped discs.
[ Transportation
- Always remove the disc before moving the drive.

Troubleshooting

* When the CD-ROM drive does not work with the hard disk drive in primary
IDE channel.
(SOLUTION)
1 . Check the CD-ROM drive Master/Slave Jumper setting.
The CD-ROM drive must be set to the Slave mode.
2 . Check to be sure your hard disk Interface type is IDE type.
3 . Check your hard disk Master/Slave Jumper setting.
Some old-version IDE type hard disks were set to Master Only mode.
In that case, contact your hard disk company and change your hard disk
jumper setting to master mode.
4 . If the CD-ROM drive does not work with above methods, you may need a
secondary IDE card. If you use the secondary IDE card, you should set the
C D-ROM drive jumper to the master mode if the CD-ROM drive is the first
device you are connecting to the secondary IDE card.
* When the CD-ROM drive does not install in OS/2 warp.
(SOLUTION)
1 . Select NON-LISTED IDE CD.
* C D-ROM drive is not present in Windows 3.1 or 3.11 or DOSSHELL.
(SOLUTION)
1 . When the WIN or DOSSHELL command lines are present in your
AUTOEXEC.BAT, make sure that the MSCDEX.EXE command line appears
before the WIN or the DOSSHELL command lines.
N OTE: For more information, consult the README.TXT file of the supplied Setup
Diskette.
E-11