Table of Contents
Advertisement
External Control Device Adjustments
12. OSD select (Command:d)
G To select OSD (On Screen Display) on/off.
Transmission
[d][ ][Set ID][ ][Data][Cr]
Data 0 : OSD off
1 : OSD on
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : OSD off
1 : OSD on
* The remote control and Monitor front panel controls
(except main power) are not operable when the Monitor
is set up to be controlled by the PC computer.
13. Abnormal state (Command:a)
G To recognize an abnormal state.
Transmission
[a][ ][Set ID][ ][FF][Cr]
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : OK
1 : Fan alarm
2 : 5V down
3 : AC down
* This function is "read only".
54
14. PIP / DW (Command:z)
G To control PIP (Picture-in-Picture) or twin picture (DW).
You can also control PIP/DW using the pip/twin picture
button on remote control or in the Special menu.
Transmission
[z][ ][Set ID][ ][Data][Cr]
Data 0 : PIP/ DW off
1 : PIP (small)
2 : PIP (large)
3 : Twin picture (DW)
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : PIP/ DW off
1 : PIP (small)
2 : PIP (large)
3 : Twin picture (DW)
* PIP only works in the following resolutions:
RGB PC 640x480 (VGA) / 800x600(SVGA) / 1024x768
(XGA) (only in vertical frequency 60Hz),
Component 480p / 720p / 1080i.
* Twin picture works only in the following resolutions:
RGB PC 640x480 (VGA) (only in vertical frequency 60Hz),
RGB DTV, Component 480p/720p/1080i.
15. PIP input select (Command:e)
G To select input source for sub picture in PIP mode.
You can also select source using PIP input button on
the remote control or in the Special menu.
Transmission
[e][ ][Set ID][ ][Data][Cr]
Data 0 : AV (VIDEO)
1 : COMPONENT
2 : S-AV (S-VIDEO)
Acknowledgement
[Set ID][:][OK][x][Data][x]
Data 0 : AV (VIDEO)
1 : COMPONENT
2 : S-AV (S-VIDEO)
* COMPONENT source only works with 480i input signal.
Advertisement
Table of Contents
