Service And Adjustment; Limbing; Pruning; Troubleshooting Chart - Jonsered 2035 Instruction Manual

LIMBING

S Always limb a tree after it is cut down. Only
then can limbing be done safely and prop-
erly.
S Leave the larger limbs underneath the
felled tree to support the tree as you work.
S Start at base of the felled tree and work to-
ward the top, cutting branches and limbs.
Remove small limbs with one cut.
S Keep the tree between you and the chain
as much as possible.
S Remove larger, supporting branches with
the , cutting techniques described in
1/3 2/3
the bucking section.
S Always use an overcut to cut small and
freely hanging limbs. Undercutting could
cause limbs to fall and pinch saw.
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.

TROUBLESHOOTING CHART

Engine will not start.
S Ignition switch off.
S Engine flooded.
S Fuel tank empty.
S Spark plug not firing.
S Fuel not reaching carburetor.
Engine will not idle properly.
S Carburetor requires adjustment.
S Crankshaft seals worn.
Engine will not accelerate, lacks
power, or dies under a load.
S Air filter dirty.
S Spark plug fouled.
S Carburetor requires adjustment.
Engine smokes excessively.
S Too much oil mixed with gasoline.
AIR FILTER
CAUTION
: Do not clean filter in gaso-
line or other flammable solvent to avoid
creating a fire hazard or producing harmful
evaporative emissions.
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.

Cleaning the air filter:

S Clean the cover and the area around it to
keep dirt and sawdust from falling into the
carburetor chamber when the cover is re-
moved.
S Remove the parts as illustrated.
S Wash the filter in soap and water.
SERVICE AND ADJUSTMENTS

PRUNING

WARNING
shoulder height or below.
branches are higher than your shoulder. Get
a professional to do the job.
Make your fist cut
S
through the bottom of the limb.
Next make a 2nd cut all the way
S
through the limb. Then cut a third
overcut leaving a 1 to 2 inch collar
from the trunk of the tree.
Second cut
Third cut
Collar
S Lightly coat the filter with 2-cycle oil before
re-installing.

BAR MAINTENANCE

If your saw cuts to one side, has to be forced
through the cut, or been run with an improper
amount of bar lubrication it may be neces-
sary to service your bar. A worn bar will dam-
age your chain and make cutting
difficult.
Replace your bar if bent or the inside rails of
the bar are worn.
S Clean the oil holes after each 5 hours of
operation
S Remove sawdust from bar groove periodi-
cally with a wire or putty knife.
Guide Bar
Groove
Oil Holes

CARBURETOR ADJUSTMENTS

Carburetor adjustment is critical and if done
improperly can permanently damage your
unit. We recommend you contact an autho-
rized service dealer for adjustments.
11
: Limit pruning to limbs
Do not cut if
of the way
1/3
First cut
Pruning technique