Brookstone SMARTSET Instructions Manual page 9

291070_INS_SmartsetCloRad NEWT
3. When the desired wake-up time appears on the display, release UP or DOWN.
4. When the desired wake-up time (AM or PM) appears on the display, release
ALARM 1 or ALARM 2.
Note: If the AM indicator is on, the alarm will sound in the AM. If the AM
indicator is off, the alarm will sound in the PM.
Selecting Alarm Mode
Your SmartSet ® Clock Radio allows you to select from among three different
alarm operation modes for either alarm. The alarm modes are:
• Weekdays only—the alarm will sound on Monday through Friday
• Weekends only—the alarm will sound on Saturday and Sunday
• Everyday—the alarm will sound on all seven days.
To check the Alarm Mode setting for Alarm 1, press ALARM 1. The display will
show the Alarm 1 wake-up time, and the day of the week indicators will show
you the alarm mode selected. If all seven indicators are on, the Everyday
mode is selected. If only the Monday through Friday indicators are on, the
Weekdays-only mode is selected. If only the Saturday and Sunday indicators
are on, the Weekends-only mode is selected.
To change the Alarm Mode setting for Alarm 1, hold ALARM 1 and press
ALARM MODE until the day indicators show the desired mode setting—
Weekdays-only, Weekends-only or Everyday operation. Release ALARM MODE
and ALARM 1 and the display will return to the correct time.
Follow the same procedure to set the desired Alarm Mode for Alarm 2.
16
10/3/02 9:38 AM Page 17
SET UP
• Place your product on a level surface such as a table, desk or shelf,
convenient to an AC outlet, out of direct sunlight, and away from sources
of excess heat, dirt, dust, moisture, humidity or vibration.
• Unwind the AC power cord and extend it to its full length. Unwind the FM
lead wire antenna and extend it to its full length.
9