(1) Wall bracket with wall bracket cover TSS 3- LANNING Before deciding where to best place your speakers, survey your room and study Figures 1 and 2. The TSS 3-in-1 should be placed directly above or below the TV. Left Surround Channel (not included) Figure 1.
Tilting the Speaker If needed, the enclosed stand allows you to tilt the speaker across a wide range (i.e., upward to a maximum of 18˚ or downward to a maximum of 7˚), as shown in Figure 3. Important! Do not exceed the tilt range. Doing so may cause the speaker to fall out of its stand.
Page 4
Step Four Using the included Allen wrench, remove the top and bottom end caps of the speaker by unscrewing the single center screw on bottom. End cap Step Five Connect the wires (see page 5). Replace the end caps while capturing the wall bracket between parts A and B of the end cap, securing it in place.
Page 5
Doing so will degrade the imaging and bass response of the home theater system. After correctly placing and wiring the TSS 3-in-1 and the rest of your speaker system, adjust the levels for all of the channels as recommended by the manufacturer of your receiver/processor.
(105mm x 1019mm x 111mm) Weight 15.25 lb (6.9kg) Infinity continually strives to update and improve existing products, as well as create new ones.The specifications and construction details in this and related Infinity publications are therefore subject to change without notice.
Page 8
Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA (516) 674-4463 (USA only) www.infinitysystems.com Infinity, Harman International and MMD are registered trademarks, and Total Solutions is a trademark, of Harman International Industries, Incorporated. Dolby is a registered trademark of Dolby Laboratories. DTS is a registered trademark of DTS, Inc.
Need help?
Do you have a question about the TSS 3-IN-1 and is the answer not in the manual?
Questions and answers