Page 2
Step Two Attach alignment pin to stand, and run speaker wire up stand. NOTE: Needle-nose pliers may be required. Step Three Align and insert the alignment pin into the bottom of the speaker. Alignment Pin Alignment Pin...
Page 3
Step Four Tighten the bolts on the bottom as shown. It’s recommended that two people perform this step so that the speaker is supported while it’s on its side and the bolts are being tightened. Attach speaker wire as described in TSS-SAT4000 Owner’s Manual.
Need help?
Do you have a question about the TOTAL SPEAKER SOLUTIONS TSS-STAND4000 and is the answer not in the manual?
Questions and answers