Vfd(R,T,M)(18,24) & Vfdr18Lb10 Log Placement (5 Log Set) - Empire Comfort Systems FDR30LBP-2 Installation Instructions And Owner's Manual

VFD(R,T,M)(18,24) & VFDR18LB10 LOG PLACEMENT (5 LOG SET)
Before you begin: if you are installing logs onto the VFD(R,T,M)18 or
VFD(R,T,M)24 models, this burner assembly is supplied with a set
of five ceramic fiber logs. Do not handle these logs with your bare
hands! Always wear gloves to prevent skin irritation from ceramic
fibers. After handling logs, wash your hands gently with soap and
water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation
of this burner assembly. Sooting and other problems may result
if the logs are not properly and firmly positioned on the burner
assembly. Refer to Figure 12 and Figure 13 and corresponding
'wARNING:' when completing following log placement instruc-
tions.
1. Place front logs (#1 and #2) between front grate flange and
main burner. Align notches on front logs with locator tabs in
base.
2. Place middle log (#3) between front and rear loop of burner.
Note: Do not place log on top of pilot assembly.
3. Place rear log (#4) on rear log shelf. Bottom flange of log must
be placed between the log shelf and burner tube.
4. This step is optional for VFDR18LB10 log sets. For 18"
logsets, place front twig (#5) onto (#1) log and flat area on (#3)
log. For 24" logsets, place front twig #5 onto two pins on #3
log (if applicable). The bottom of the front twig is to be placed
behind the grate tang that is second from the left.
EMBER MATERIAL PLACEMENT ON BURNER
5. After all logs are positioned properly, apply Rockwool ember
material to the front burner port area. To apply, carefully separate
the ember material into small amounts no larger than "dime
size" pieces. Fluffed up pieces one layer thick on top of the
burner generally works best, and will provide the best ember
glow. Do not place ember material more than one layer thick.
No more than (2) two small packets of ember material (part
no. 15998) evenly placed on the burner, is recommended on
VFDR18 and VFDR24 models. Using additional ember material
will decrease the amount of ember glow effect. Extra ember
material should be saved for future ember applications as
necessary. See Figure 13.
Description
VFD(R,T,M)18 Embers
VFD(R,T,M)24 Embers
VFD(R,T,M)30 Embers
Platinum Bright Embers
NOTICE: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with standard
embers) to the burner.
Page 14
3
Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved
with this appliance may result in property damage or
personal injury.
Attention: Do not use Figure 12 or Figure 13 to order logs. Refer
to Parts Lists and Parts Views to order logs and/or ember material
for your appropriate model.
Part #
15998
15998
15999
PE20-1
4
5
Figure 12
wARNING
Figure 13
2
1
OPTIONAL LOG
PLACEMENT FOR
VFDR18LB10
EMBER MA TERIAL
PLACEMENT
(SHADED AREA ONLY)
27604-3-0411