Empire Comfort Systems METRO BMHK-18N-1 Installation Instructions And Owner's Manual
Empire Comfort Systems METRO BMHK-18N-1 Installation Instructions And Owner's Manual

Empire Comfort Systems METRO BMHK-18N-1 Installation Instructions And Owner's Manual

Metro series metro series decorative burner

Advertisement

Quick Links

EMPIRE
EMPIRE
Comfort Systems
CONGRATULATIONS on the purchase of your new
DECORATIVE GAS BURNER! Your Decorative Gas
Burner is designed and intended for installation in an
approved, existing, fully vented, wood-burning fireplace,
with a gas hook-up. Match Throw units must be fu-
eled by Natural Gas only. Gas Control Valve units may
be fueled by either Natural or Liquid Propane (LP) gas.
Liquid Propane units must use an LP change kit.
WARNING: If the information in these instructions
are not followed exactly, a fire or explosion may
result causing property damage, personal injury or
loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
— WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not use
any phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call the
fire department.
— Installation and service must be performed by a
qualified installer, service agency or the gas sup-
plier.
Carton Contents:
1 - METRO Series Burner Pan (NG or match throw)
1 - Grate
1 - 3/8" X 14" Aluminum Gas Line with adapter
1 - Bag Sand
1 - Bag Glowing Embers (18" & 24" Sets)
2 - Bags Glowing Embers (30" Sets)
2 - Bags Lava Rock (Cinders)
1 - Damper Clamp Assembly
1 - Manual Pack with Warranty Card
INSTALLATION INSTRUCTIONS
AND OWNER'S MANUAL
METRO SERIES DECORATIVE
BURNER
(REQUIRES VENTED DECORATIVE LOG SET)
FOR INSTALLATION IN
SOLID-FUEL BURNING FIREPLACES
MODELS
BMHK-18N-1
BMHK-24N-1
BMHK-30N-1
WARNING: This log set is to be installed only in
a solid-fuel burning fireplace with a working flue
constructed of non-combustible material. The vent
damper must also have a damper clamp attached to
it to keep the damper from accidentally closing dur-
ing operation.
WARNING: If not installed, operated and maintained
in accordance with the manufacturer's instructions,
this product could expose you to substances in fuel
or from fuel combustion which can cause death or
serious illness.
WARNING: This appliance must be installed only in
a solid-fuel burning fireplace with a working flue and
construction of noncombustible materials. This unit
is NOT for use with solid fuel. Solid fuels shall NOT
be burned in a fireplace where a decorative appli-
ance is installed.
General Information: These instructions are intend-
ed as a general guide and do not supersede national
or local codes in any way. Authorities having juris-
diction should be consulted before installation.
Installation and provision for combustion and ven-
tilation air must conform to the National Fuel Gas
Code, ANSI Z223.1, or CAN/CGA-B149.1, Natural
Gas Installation Code, or CAN/CGA-B149.2, Propane
Installation Code.
IMPORTANT! Read these instructions carefully be-
fore installing or operating this gas appliance. These
instructions should be left with the homeowner for
future reference.
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the METRO BMHK-18N-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Empire Comfort Systems METRO BMHK-18N-1

  • Page 1 (REQUIRES VENTED DECORATIVE LOG SET) FOR INSTALLATION IN SOLID-FUEL BURNING FIREPLACES MODELS CONGRATULATIONS on the purchase of your new BMHK-18N-1 DECORATIVE GAS BURNER! Your Decorative Gas BMHK-24N-1 Burner is designed and intended for installation in an BMHK-30N-1 approved, existing, fully vented, wood-burning fireplace, with a gas hook-up.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS SECTION PAGE IMPORTANT SAFETY INFORMATION ............... 3-4 SAFETY INFORMATION FOR USERS OF LP-GAS ..........5 INTRODUCTION ..................... 6 SPECIFICATIONS ....................6 INSTALLATION ....................7 - 12 FINAL SET UP ...................... 13 LIGHTING INSTRUCTIONS - MATCH THROW UNITS ........14 LIGHTING INSTRUCTIONS - SAFETY PILOT UNITS .........
  • Page 3: Important Safety Information

    IMPORTANT SAFETY INFORMATION Installer: Please leave these instructions with the owner for various components of this appliance are treated future reference. with certain oils, films or bonding agents. These bonding agents are not harmful but may produce For Installation In Solid Fuel Burning Fireplaces. Do not burn annoying smoke and smells as they are burned off wood or solid fuels in a fireplace where a decorative gas log during initial operation of the appliance.
  • Page 4 IMPORTANT SAFETY INFORMATION WARNING: Follow all gas leak check procedures in this manual, WARNING prior to operation. The damper clamp must be installed in a manner which will WARNING: Fuels used in gas or oil-fired appliances, and the maintain the minimum permanent damper vent opening at all products of combustion of such fuels, contain chemicals known to times.
  • Page 5: Safety Information For Users Of Lp-Gas

    SAFETY INFORMATION FOR USERS OF LP-GAS Propane (LP-Gas) is a flammable gas which can cause fires SOME POINTS TO REMEMBER and explosions. In its natural state, propane is odorless and • Learn to recognize the odor of LP-gas. Your local LP-Gas colorless.
  • Page 6: Introduction

    INTRODUCTION Introduction General Information Always consult your local Building Department regarding regula- Any alteration of the original design, installed other than as tions, codes or ordinances which apply to the installation of a shown in these instructions or use with a type of gas not vented decorative gas log set in a solid-fuel burning fireplace.
  • Page 7: Installation

    INSTALLATION Note: Installation can be made easier if two or more people coop- IMPORTANT erate in locating and installing the unit. Seal any fresh air vents or ash clean-out doors located on the floor or wall of the fireplace. If this is not performed, drafting LOCATING THE UNIT may cause pilot outage or sooting.
  • Page 8 INSTALLATION SET UP AND ASSEMBLY FOR MATCH THROW INSTALLATIONS Your Metro Decorative Burner comes read for as assembly con- Place the Metro burner pan into the fireplace (unit is pack- nections particular for use in your area. aged as a match-throw single burner assembly. The valve, pilot and gas train must be assembled.).The unit should be centered from both side to side, and front to back.
  • Page 9 INSTALLATION FOR VALVE/PILOT INSTALLATIONS It will be easier to assemble the burner/gas train outside of the fireplace and then place the entire assembly into the fireplace for final gas hook-up. Follow the instructions that are included with the valve/pilot kit and/or the instructions below. Figure 3 - Valve/Pilot Assembly Parts Figure 4 - Rear View Standard Assembly Figure 5 - Front View See Thru Assembly...
  • Page 10 INSTALLATION STANDARD PAN - VALVE/PILOT ASSEMBLY INSTALLING THE APPLIANCE INTO THE Assemble the valve/pilot kit. See Figures 3 to 5. FIREPLACE Noting the distance between the grate tines, place the pilot Place the Metro burner pan assembly into the fireplace (unit mounting bracket on the rear of the burner pan between is packaged as a match-throw, single burner assembly.
  • Page 11 INSTALLATION FOR UNITS WITH REMOTE SYSTEMS All burner systems are capable of operating with a latching sole- noid remote control system. See the instructions packaged with the remote system that you have purchased for detailed installa- tion and operational characteristics. The following instructions are a general guide for installation only.
  • Page 12 INSTALLATION HAND HELD REMOTE RECEIVER WALL MOUNT REMOTE RECEIVER See the instructions packaged with the remote system for direc- See the instructions packaged with the remote system for direc- tions on programming the coding switches on both transmitter tions on programing (“learning”) both transmitter and receiver. and receiver.
  • Page 13: Final Set Up

    FINAL SET UP Remove all contents from the Decorative Gas Log shipping WARNING: container (Box Two). Failure to position the parts in accordance with all included Check the contents of the shipping container against the pictures, diagrams and drawings, or failure to use only parts shipping and packing list or the parts list in this manual.
  • Page 14: Lighting Instructions - Match Throw Units

    If after repeated attempts the appliance does place is in the OFF position. not ignite, contact your installer or the Empire Comfort Systems Wait five minutes to clear out any gas. If you smell gas, Customer Service Center.
  • Page 15: Lighting Instructions - Safety Pilot Units

    LIGHTING INSTRUCTIONS - SAFETY PILOT UNITS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. This appliance has a pilot which must be lighted by hand. C.
  • Page 16: Operation

    OPERATION Units with a Gas Control Valve FOR YOUR SAFETY READ BEFORE LIGHTING Figure 21 - Metro Burner Review Standard Pan with Valve WARNING Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been under water.
  • Page 17: Maintenance And Service

    MAINTENANCE & SERVICE The Decorative Gas Log Set should be thoroughly inspected on a Check for creosote and soot build-up in chimney and/or regular basis at least once a year by a qualified installer. vents and clean if necessary. At the beginning of each heating season, the system should be Inspect the pilot and burners (if applicable).
  • Page 18: Troubleshooting

    TROUBLESHOOTING PROBLEM OBSERVED POSSIBLE CAUSE CORRECTIVE MEASURE See “What to do if you smell gas” Pages 1, 14, Gas odor during setup Gas Leak and 15. Check all gas connections See “What to do if you smell gas” Pages 1, 14, Gas odor before first ignition Gas Leak and 15.
  • Page 19: Master Parts Distributor List

    This list changes from time to time. For the current list, please click on the Master Parts button at www.empirecomfort.com. Please note: Master Parts Distributors are independent businesses that stock the most commonly ordered Original Equipment repair parts for Heaters, Grills, and Fireplaces manufactured by Empire Comfort Systems Inc. Dey Distributing Victor Division of F.
  • Page 20: Parts List

    PARTS LIST PART NO INDEX DESCRIPTION NUMBER BMHK18N BMHK24N BMHK30N FG10096 GRATE 21 INCH STANDARD FG10102 GRATE 24 INCH STANDARD FG10105 GRATE 30 INCH STANDARD FG10288 SINGLE BURNER PAN 21 INCH FG10103 SINGLE BURNER PAN 24 INCH FG10106 SINGLE BURNER PAN 30 INCH FG10098 FG10098 FG10098...
  • Page 21: Parts View

    PARTS VIEW FG10099-3-0214 Page 21...
  • Page 22: Warranty

    WARRANTY Empire Comfort Systems Inc. warranties this hearth product to be free from defects at the time of purchase and for the periods specified below. Hearth products must be installed by a qualified technician and must be maintained and operated safely, in accordance with the instructions in the owner’s manual.
  • Page 23: Appliance Service History

    APPLIANCE SERVICE HISTORY Date Dealer Name Service Technician Name Service Performed/Notes FG10099-3-0214 Page 23...
  • Page 24 Empire Comfort Systems Inc. EMPIRE EMPIRE 918 Freeburg Ave. Belleville, IL 62220 If you have a general question about our products, please e-mail us at info@empirecomfort.com. If you have a service or repair question, please contact your dealer. Comfort Systems www.empirecomfort.com...

This manual is also suitable for:

Metro bmhk-24n-1Metro bmhk-30n-1

Table of Contents