Minolta Dimage S304 Instruction Manual page 52

DATA-TRANSFER MODE
DISCONNECTING THE CAMERA FROM THE COMPUTER
Never disconnect the camera when the access lamp is lit - the data or
CompactFlash card may permanently be damaged.
WINDOWS 98 AND 98SE
Confirm that the access lamp is not lit. Turn the mode dial to another position and then
disconnect the USB cable.
WINDOWS ME AND WINDOWS 2000 PROFESSIONAL
To disconnect the camera, click once on the unplug-or-eject-hardware icon
located on the task bar. A small window will open indicating the device to
be stopped.
Click on the small window
to stop the device. The
safe-to-remove-hardware
window will appear. Click
"OK." Turn the mode dial to
another position and then
disconnect the USB cable.
When more than one external device are connected to the computer, the
unplug-or-eject-hardware window can be used. To disconnect the camera,
double click on the unplug-or-eject-hardware icon located on the task bar
to activate the window.
102
A confirmation screen will appear to indicate the
devices to be stopped. Clicking "OK" will stop the
device.
A third and final screen will appear to indicate the
camera can be safely disconnected from the
computer. Turn the mode dial to another position
and then disconnect the USB cable.
MACINTOSH
Confirm that the access lamp is not lit and then drag the mass-storage device icon and
drop it into the trash.
Disconnect the USB cable.
• If the USB cable is disconnected before performing the first step, an alert message will
appear. Always complete the first step before disconnecting the USB cable.
The hardware devices to be
stopped will be displayed.
Highlight the device by click-
ing on it then click "Stop."
103