Speaker Control; Fm Mono; Display Settings; Am Display - C. Crane CC Witness + Instruction Manual

Display Screens and Functions
manually set lower than the "Default Volume"
setting, it will not change at power-up.
e. "Speaker Control"
or off while the Witness+ is in the optional cradle
accessory.
f. "FM Mono" — When this setting is on, FM will
always play in mono.

4. "Display Settings"

a. "AM Display" — This setting is used to improve
the AM radio reception by turning the display
screen "OFF". If any button is pressed, the display
screen will turn "ON" for three seconds, then turn
"OFF" again.
b. "Backlight Time" — Use the slider bar to set the
amount of time that the display backlight is to
Page 18
— Turns the speakers on
remain "ON" between button presses. If set to
"Continue", the backlight will remain "ON".
Adjusting the Backlight Time setting is useful for
conserving battery power, as more power is used
when the backlight is "ON".
c. "LCD Control" — Use the slider bar to adjust
the contrast of the display. When set too low, the
display will not be as visible. The default setting of
"05" is usually best.
d. "ID3 Tag" — This setting is used to display added
information that may be attached to computer audio
files. When set to "ON" and an audio file with ID3
tags is selected, the title of the file may also contain
the Artist, Album, track time, and more.
When set to "OFF" only the title of the audio file will
be displayed. Most ID3 tags can be viewed and
edited with a Windows computer by selecting the
file "Properties", then selecting the "Summary"
tab.
CC Witness+