Using The Color On-Screen Display; Using The Screen On-Screen Display - IBM P202 Operating Instructions Manual

Customizing Your Monitor

Using the COLOR On-screen Display

You can change the monitor's color temperature. For
example, you can adjust or change the colors of a picture on
the screen to match the actual colors of the printed picture.
Once the setting is adjusted, it will be stored in memory for
all input signals received.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select "
COLOR," and press the
The COLOR OSD appears.
3
Press the >?// buttons to select the color
temperature.
There are three color temperature
modes in the OSD.
The preset adjustments are:
5000K, 6500K, 9300K
4
Fine tuning the color temperature
Press the ¨./> buttons to select an item and adjust by
pressing the >?// buttons.
Select R (red), G (green), or B (blue) BIAS to adjust the
black level of each color's signal.
Select R (red), G (green), or B (blue) GAIN to adjust the
white level of each color's signal.
The "5000K," "6500K" or "9300K" disappears and the
new color settings are memorized for each of the three
color modes.
The color temperature modes change as follows:
5000Kn 1, 6500Kn 2, 9300Kn 3
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory settings.
10
button again.
COLOR
5000K 6500K 9300K
R B I AS 50
G B I AS 50
B B I AS 50
R GAIN 50
G GAIN 50
B GAIN 50
COLOR
1 6500K 9300K
R B I AS 76
G B I AS 50
B B I AS 50
R GAIN 50
G GAIN 50
B GAIN 50
button again.
Using the SCREEN On-screen
Display
You can adjust convergence settings to eliminate red or blue
shadows that may appear around objects on the screen.
Adjust the CANCEL MOIRE function to eliminate wavy or
elliptical patterns that may appear on the screen.
Adjust the LANDING function to correct color imbalances
at the four corners of the screen due to influence from the
earth's magnetism.
Once CANCEL MOIRE is adjusted, it will be stored in
memory for the current input signal. All other adjustments
will be stored in memory for all input signals received.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select "
SCREEN," and press the
The SCREEN OSD appears.
3
Press the ¨./> buttons to select the item you want
to adjust.
Select To
adjust the horizontal convergence
H CONVERGENCE
adjust the vertical convergence
V CONVERGENCE
TOP adjust the screen's upper vertical
convergence
V CONVER TOP
BOT
adjust the screen's lower vertical
V CONVER BOTTOM convergence
button again.
SCREEN
TOP
BOT
26
ADJ
H CONVERGENCE