Table of Contents
Advertisement
NOTES
• To correctly play back movies recorded with x.v.Color (" 156) on an
HDTV compatible with this standard, additional settings may be
required on the connected HDTV. Refer to the TV's instruction manual.
• We recommend powering the camcorder using the compact power
adapter.
• Connection $: When you play back your 16:9 movies on standard TV
sets with a 4:3 aspect ratio, the TV set will switch automatically to wide-
screen mode if it is compatible with the Video ID-1 system. Otherwise,
change the aspect ratio of the TV manually.
Copying a Single Photo
Operating modes:
1 In single photo view, select the photo you want to copy.
Check that you are viewing photos recorded in the built-in memory. (#
appears next to the photo number.)
2 Touch the screen to display the playback controls.
3 Copy the photo.
[Edit]
[Copy ($)]
(
4 Drag your finger left/right to select another photo to copy or touch
[#].
Copying Photos from the Index Screen
Operating modes:
1 Open the [Photos] index screen.
Check that you have selected the # tab (built-in memory).
2 Touch [%] to open the photo selection screen.
3 Touch on the individual photos you want to copy.
• A checkmark & will appear on photos selected. Touch a selected
photo again to remove the checkmark.
• To select all the photos at once: Touch [Select All] instead of touching
individual photos. (Remove in advance any checkmarks from photos
you may have selected individually.)
4 Copy the photos.
[Edit]
[Copy ($)]
(
* Touch [Stop] to interrupt the operation while it is in progress.
125
External Connections
!
[: Proceed]
[Yes]
(
(
[Yes]*
[OK]
(
(
127
External Connections
!
Saving and Sharing Your Recordings
! Copying Recordings to a Memory Card
You can copy your recordings only one-way: from the built-in memory
to the memory card. Scenes and photos will be copied from the index
screen you selected to the corresponding index screen on the memory
card.
Please read the IMPORTANT section (" 128) before using an Eye-Fi
card.
Copying Scenes
Operating modes:
1 Open the index screen that contains the scenes you want to copy.
• Check that you have selected the # tab (built-in memory).
• [Original] or [Video Snapshot] ! [Original] index screen: To copy all
the scenes recorded on a specific date, narrow down the scenes
shown to scenes recorded on that date (" 55).
2 Touch [%] to open the scene selection screen.
When you copy scenes from the [Playlist] index screen (including the
playlist of video snapshot scenes), you cannot select individual scenes;
instead, the entire playlist will be copied. Skip directly to step 4.
3 Touch on the individual scenes you want to copy.
• A checkmark & will appear on scenes selected. Touch a selected
scene again to remove the checkmark.
• To select all the scenes at once: Touch [Select All] instead of
touching individual scenes. (Remove in advance any checkmarks
from scenes you may have selected individually.)
4 Copy the scenes.
[Edit]
[Copy ($)]
(
* Touch [Stop] to interrupt the operation while it is in progress.
126
External Connections
!
IMPORTANT
• Observe the following precautions while the ACCESS indicator is on or
flashing. Failing to do so may result in permanent data loss.
- Do not open the memory card slot cover.
- Do not disconnect the power source or turn off the camcorder.
- Do not change the camcorder's operating mode.
• When copying photos onto an Eye-Fi card, photos will be uploaded
automatically if you are within the range of a configured network. Always
verify that Eye-Fi cards have been approved in the country/region of
use. See also Using an Eye-Fi card (" 146).
NOTES
• If the memory card slot cover is open, or the LOCK switch on the mem-
ory card is set to prevent writing, you will not be able to copy recordings
to the memory card.
• Scenes that were edited using the supplied software ImageMixer 3 SE
and were then written back to the camcorder cannot be copied to the
memory card.
• If there is not enough space on the memory card, as many photos as
possible will be copied before stopping the operation.
Saving Recordings on a Computer
Movies recorded with this camcorder are saved in the built-in memory
(! only) or on the memory card. Because space is limited,
make sure to save your recordings on a computer on a regular basis.
Saving Movies
With the supplied software ImageMixer 3 SE you can save scenes to
your computer. If necessary, video files previously saved on a
computer can be restored back to the camcorder. The software also
offers many options for organizing your video library, editing video and
more.
Installation
See 'PIXELA Applications' Installation Guide.
128
!
External Connections
[Yes]*
[OK]
(
(
Advertisement
Table of Contents
